| SMAW (Stick) | Outdoor repair, construction, maintenance, and jobs where portability and simple setup matter. | Carbon steel, low-alloy steel, stainless steel, and some cast irons with suitable electrodes. | Constant-current power source; commonly about 30–300 A, depending on electrode size and work. | AC or DC may be used, depending on the electrode. DC electrode-positive is common, but electrode requirements vary. | Inverter or transformer-rectifier power source, electrode holder, work clamp, and leads. | Check the electrode’s recommended current and polarity, available input power, open-circuit voltage, and duty cycle. |
| GMAW (MIG/MAG) | Shop fabrication, vehicle repair, and production work requiring relatively high deposition rates and continuous wire feeding. | Carbon steel, stainless steel, and aluminum with the appropriate wire, shielding gas, and setup. | Usually a constant-voltage source with a wire feeder; commonly about 30–400 A across equipment sizes. | Typically DCEP. Uses shielding gas; gas composition depends on the wire and material. | Power source, wire feeder, welding gun, gas regulator/flowmeter, and suitable wire-feed rolls and liner. | Match output and duty cycle to material thickness and production rate. Confirm input supply, wire diameter range, and gas availability. |
| FCAW (Flux-Cored) | Structural fabrication, heavier fabrication, and outdoor work where higher deposition or improved tolerance to drafts is useful. | Primarily carbon and low-alloy steels; stainless flux-cored wires are also available for suitable applications. | Usually a constant-voltage source with a wire feeder; commonly about 100–500 A, depending on wire and application. | Gas-shielded wires commonly use DCEP. Self-shielded wires may use DCEP or DCEN; follow the wire specification. | Power source, feeder, gun, and either shielding-gas equipment or a setup for self-shielded wire. | Identify whether the wire is gas-shielded or self-shielded, verify polarity, and check wire compatibility and fume-control needs. |
| GTAW (TIG) | Precision work, thin sections, clean welds, and applications where careful control of the weld pool is important. | Carbon steel, stainless steel, aluminum, copper alloys, and other weldable metals with suitable procedures. | Constant-current source; commonly about 5–300 A, with specialized equipment available outside this range. | DCEN is common for steels and many other metals. AC is commonly used for aluminum and magnesium. Inert shielding gas is required. | TIG-capable power source, torch, gas regulator/flowmeter, tungsten electrodes, and filler rods where needed. | Check low-current control for thin material, AC capability for aluminum, torch cooling requirements, and gas coverage. |
| SAW (Submerged Arc) | High-volume, mechanized welding of long seams, large vessels, beams, and heavy plate. | Most commonly carbon and low-alloy steels; consumable combinations must suit the base metal and procedure. | High-output constant-voltage or constant-current systems; commonly about 200–1,000 A, depending on configuration. | DC electrode-positive is common; AC and other configurations are used for particular setups. Flux covers the arc during welding. | High-capacity power source, wire-feed system, flux delivery and recovery equipment, and a mechanized carriage or positioner. | Confirm automation needs, joint access, flux handling, power capacity, travel speed, and duty cycle for continuous operation. |