| General-purpose, peroxide-cured VMQ | Broad everyday silicone performance; commonly available in a wide range of hardnesses, often about 20–80 Shore A. Many compounds are designed for service around −50 to +200°C, subject to grade and exposure. | Commonly processed by compression, transfer, or injection molding. Cure conditions depend on the formulation; post-curing may be specified to reduce residual cure by-products or improve properties. | General seals, gaskets, molded parts, and applications where a balanced cost and performance profile is needed. | Often a practical starting point, but not automatically suitable for low-extractables, extreme-temperature, or high-tear requirements. |
| Platinum-cured VMQ | Addition-cure grades can offer low volatile by-products and are often selected where low extractables, odor, or contamination risk matters. Actual compliance depends on the specific formulation and testing. | Requires careful two-part mixing and clean handling. Sulfur-containing materials, amines, some metal compounds, and other contaminants can inhibit cure; follow the compound supplier’s processing guidance. | Applications with tighter cleanliness or extractables requirements, including selected food-contact, medical, and precision molded parts when the grade is qualified for that use. | May cost more and is more sensitive to cure inhibition. “Platinum-cured” alone does not establish regulatory approval or suitability. |
| High-tear VMQ | Formulated to resist tearing and damage during demolding or repeated flexing better than standard grades. Tear strength varies substantially by formulation and test method. | Can be processed using standard silicone molding methods, but mold design, venting, cure conditions, and demolding practice still affect finished-part quality. | Thin sections, intricate molded parts, flexible components, and products exposed to repeated handling or mechanical stress. | Can improve durability, but may not be the lowest-cost option. Request tear data using a stated test method and specimen geometry. |
| Low-temperature VMQ | Specially formulated grades retain flexibility at lower temperatures than many standard compounds; some are designed for service near −60°C or below. Limits are grade-specific. | Generally uses conventional silicone molding processes. Validate cure, compression set, and sealing performance at the actual operating temperature. | Cold environments, outdoor equipment, refrigeration-related components, and seals that must remain flexible in low temperatures. | Low-temperature flexibility is not the same as proven low-temperature sealing. Check the required test method and temperature range. |
| Heat-resistant VMQ | Specialty grades can be designed for longer exposure to elevated temperatures than general-purpose VMQ; some are rated for continuous service around 225–250°C under defined conditions. | Mold using the grade-specific cure schedule. Assess aging, compression set, and mechanical-property retention after exposure to the real temperature and duration. | Hot-air, oven, and engine-compartment applications where conventional VMQ does not provide enough thermal-aging margin. | A maximum temperature rating is not a guarantee of long-term performance. Heat, pressure, and contact media can shorten service life. |
| Electrically conductive VMQ | Conductive fillers provide electrical conduction or static dissipation. Volume resistivity can vary by many orders of magnitude, depending on filler, formulation, and test conditions. | Filler loading can affect flow, mold wear, color, surface finish, and mechanical properties. Specify the required resistivity range and test method. | Grounding paths, static-control parts, and selected EMI shielding applications where a conductive elastomer is required. | Conductivity may come with reduced elongation or other property changes. Confirm electrical performance on the finished part, not just the raw compound. |
| Sponge or cellular VMQ | Cellular structure provides low density and compressibility; available as open-cell or closed-cell material depending on the product. Compression behavior and fluid resistance depend on the construction. | May be supplied as molded sponge or converted sheet and profile. Specify cell structure, density, skin, dimensions, and compression requirements. | Cushioning, vibration isolation, thermal insulation, and lightweight seals where a cellular material is appropriate. | Not interchangeable with solid VMQ: sealing, water uptake, compression set, and mechanical strength depend on cell type and construction. |