| 1 | Direct-fit in-tank replacement | Vehicle-specific; verify the rated flow for the exact application | Original-style module or pump assembly in the factory tank | Varies by exact part and seller; check written terms | Stock vehicles needing an original-style replacement | Connector, module design, pressure rating, and vehicle compatibility |
| 2 | Low-pressure carbureted pump | Commonly advertised around 20–35 GPH (76–132 LPH); pressure is low by design | Carbureted fuel systems; often mounted externally | Varies by exact part and seller; check written terms | Carbureted street cars and mild engine builds | Required pressure, regulator needs, and fuel compatibility |
| 3 | Standard EFI replacement pump | Application-specific; compare flow at the vehicle’s specified operating pressure | Electronic fuel-injection systems, commonly installed in-tank | Varies by exact part and seller; check written terms | Factory-power gasoline vehicles and routine repairs | Specified pressure, electrical connector, and module compatibility |
| 4 | High-flow in-tank pump, approximately 190–255 LPH class | Often advertised in the 190–255 LPH range; delivery falls as pressure rises | Compatible in-tank hanger or module; vehicle-specific installation may be needed | Varies by exact part and seller; check written terms | Mildly modified EFI engines and moderate power increases | Flow at target pressure, wiring capacity, and tank-hanger fit |
| 5 | High-flow in-tank pump, approximately 300–340 LPH class | Often advertised around 300–340 LPH under specified test conditions | Modified in-tank systems with a compatible pump mount and wiring | Varies by exact part and seller; check written terms | Higher-output naturally aspirated or boosted EFI builds | Flow at working pressure, fuel type, current draw, and heat management |
| 6 | High-capacity in-tank pump, 400+ LPH class | Some units are advertised above 400 LPH; ratings are test-condition dependent | Custom or upgraded tank assemblies with suitable wiring and plumbing | Varies by exact part and seller; check written terms | High-power builds where a single pump meets the calculated fuel demand | Verified flow at operating pressure, electrical load, and fuel-system capacity |
| 7 | External inline EFI pump | Model-dependent; compare the flow curve at the required pressure | Inline installation between tank and engine, subject to inlet and mounting requirements | Varies by exact part and seller; check written terms | Custom systems, accessible service layouts, or supplemental fuel delivery | Inlet restriction, noise, mounting position, and fuel-pressure rating |
| 8 | Diesel lift / feed pump | Engine- and system-specific; gasoline-pump flow ratings are not interchangeable | Diesel low-pressure supply circuit or vehicle-specific assembly | Varies by exact part and seller; check written terms | Replacing a diesel feed pump with the correct system-rated unit | Diesel compatibility, pressure specification, filtration, and exact application |
| 9 | Flex-fuel-compatible pump | Depends on the specific pump and fuel blend; confirm flow using the intended fuel | Compatible EFI tank system configured for the vehicle and fuel blend | Varies by exact part and seller; check written terms | Vehicles calibrated for gasoline-ethanol blends within the pump’s stated limits | Explicit fuel-blend approval, seals, wiring, and required flow margin |
| 10 | Dual in-tank pump setup | Combined flow depends on pump models, controls, plumbing, and operating pressure | Custom tank or multi-pump hanger with dedicated electrical control | Each component has its own terms; check coverage for the complete setup | High-demand builds requiring staged or parallel fuel delivery | Pump staging, wiring relays, fuel return, tank baffling, and total system capacity |